Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you can not find what you are looking for please submit a records request.

Case: T13DV04786

Case Details

Status:

REFERRED

Type:

RES: MINIMUM HOUSING
Address:

Entered Date:

07/09/2013

Applicant:

FOUNDATION FOR HEALTH, RESEARCH & PREVENTION ATTN: HEIDEMANN GLENN A

Description:

Electric service violations

Case Violations

Case Number: T13DV04786
Case Status: REFERRED
Case Description: RES: MINIMUM HOUSING
Total Violations: 1
Violation Date Code Statue
07/09/2013 T.C. Ch. 16, Sec. 16-11(c) ELECTRICAL SYSTEM. (1) All dwellings and dwelling units shall be provided with electrical service. Electrical facilities connected to or in any building or structure are to be maintained hazard-free and in a state of good repair. The electrical system shall be free from such hazards as bare wiring; overloaded circuits or services; equipment not properly grounded; over-fused circuits; misuse of wiring, including the use of extension cords in lieu of permanent wiring; non-approved wiring; and wiring exposed to moisture or extreme heat. Broken, loose, frayed, inoperable, defective or missing portions of the electrical service, lines, switches, outlets, fixtures and fixture coverings shall be repaired or replaced. (2) All electrical equipment, wiring and appliances shall be installed and maintained in a safe manner and in accordance with all applicable laws.

Outstanding Inspections

Case Number: T13DV04786
Case Status: REFERRED
Case Description: RES: MINIMUM HOUSING
Total Outstanding Inspections - 1
End Date Description Inspector Results Comments
INSP - FOLLOW UP CODE ENFORCE None Not Inspected

Completed Inspections

Case Status: REFERRED
Case Number: T13DV04786
Case Description: RES: MINIMUM HOUSING
Total Completed Inspections - 1
End Date Description Inspector Results Comments
07/01/2013 INSP - INITIAL CODE ENFORCMENT RHOLLAND Approved Service disconnect has sever deterioration at grounded/neutral terminal. This is due to loose connections causing heat damage to the conductor and insulation. There is also corrosion to the point of causing metal failure to the terminal. The spice connector has not been installed to manufactures instructions. ther are too many conductors in the connector. The srevice disconnects are located over the gas piping and meters. It is noted that there is additional electrical added on the exterior of the unit.