Permit Review Detail
Review Status: Completed
Review Details: MOBILE HOME
Permit Number - T20MH00131
Review Name: MOBILE HOME
Review Status: Completed
| Review Date | Reviewer's Name | Type of Review | Description | Status | Comments |
|---|---|---|---|---|---|
| 02/25/2021 | STEVE SHIELDS | ZONING | REVIEW | Reqs Change | PDSD TRANSMITTAL FROM: PDSD Zoning Review PROJECT: T20MH00131 8771 E Escalante Rd Mobile Home Setup Residential (1st Review) TRANSMITTAL DATE: February 25, 2021 This site is located in the C-1 zone (UDC 4.7.20). A mobile home is not a permitted use in this zone (Table 4.8-4). Per Unified Development Code Table 4.8-4 a mobile home is not allowed in the C-1 Zone. A Manufactured Home is allowed. The following note shall be provided on the plot plan: 1. Per UDC Section 11.3.7.A.2 A multisectional mobile home dwelling manufactured after June 15, 1976, to standards established by the U.S. Department of Housing and Urban Development that has external dimensions of at least 24 feet by 40 feet and is installed on a permanent foundation. A manufactured housing unit is considered equivalent to a single-family dwelling. To be considered a manufactured housing unit under this UDC , a wall must be installed continuously, except for ventilation and access, along the entire perimeter of the unit between the unit and the ground to give it the appearance of a site -built house. The wall must be of masonry construction or similar material. The tongue, axles, transporting lights, and towing apparatus must be removed before occupancy. Based on the dimensions provided on the plan the proposed dwelling unit is only 20’-0” wide and does not meet the width requirements above. A Board of Adjustment for Variance is required. Variance requirements can be found at: https://www.tucsonaz.gov/files/pdsd/codes/Zoning_Administration_Application_BA_fillable.pdf The following comments need to be addressed: The plot plan needs to meet the requirements found at: https://www.tucsonaz.gov/files/pdsd/forms/Residential_Plot_Plan_Requirements.pdf 1. Indicate the name of the Owner and the property address. 2. Show the square footage of each of the following: Lot Existing dwelling Addition to dwelling(s) Accessory structure(s) Additions(s) to accessory structure(s) Total under roof area 3. Provide lot coverage (the area of the site occupied by buildings, storage areas and vehicular use areas) information for the following: Square footage of vehicular use area Total square footage of building area and vehicular use area proposed. 4. Provide the current lot coverage calculation. 5. Indicate the maximum structure height. 6. Provide the height of the exterior walls of the new building addition or structure measured from the average height to the highest point under the roof or to the top of the parapet wall. North: feet high South: feet high East: feet high West: feet high 7. Show location of nearest fire hydrant. 8. Show locations of utility lines for water, sewer, electric and gas. 9. Indicate the zoning of the property and of the surrounding properties. 10. Provide a legal description of the property (i.e. the subdivision name and lot number or metes and bounds legal if not in a subdivision). If you have any questions about this transmittal, please contact Elisa Hamblin at Elisa.Hamblin@tucsonaz.gov |
| 02/25/2021 | SSHIELD1 | ENGINEERING | REVIEW | Passed | |
| 02/25/2021 | SSHIELD1 | NPPO | REVIEW | Passed | |
| 02/25/2021 | KEN VAN KARSEN | BUILDING-RESIDENTIAL | REVIEW | Completed |