Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you can not find what you are looking for please submit a records request.
Permit Review Detail
Review Status: Completed
Review Details: BILLBOARD - BLDG/ELEC30days
Permit Number - T20BU00204
Review Name: BILLBOARD - BLDG/ELEC30days
Review Status: Completed
| Review Date | Reviewer's Name | Type of Review | Description | Status | Comments |
|---|---|---|---|---|---|
| 10/08/2020 | ERIC NEWCOMB | BUILDING-COMMERCIAL | REVIEW | Approved | |
| 10/08/2020 | DAN SANTA CRUZ | ELECTRICAL-COMMERCIAL | REVIEW | Approved | |
| 11/05/2020 | GLENN MOYER | ADMINISTRATIVE | ADMIN REVIEW | Denied | Below are comments on the electrical repair resubmittal for COT ID# 422 at 1114 North Country Club Road (T20BU00204 R) Sheet 1 of 2 1. In Title Block, please indicate Sheet 1 of 2. Sheet 2 of 2 1. The resubmittal was not responsive to Comment #7 on Sheet 2 of the original submittal; in Existing Electrical Riser Diagram, depict 2” IMC service riser attached to (left side/north face of) I-beam with indication to be removed in addition to the 3/4” service riser shown & clarify the designation note so that both the referenced 2” IMC and ¾” EMT are to be removed and the UG replacement 2 ½” IMC conduit is to be attached to bottom of meter socket box. [Note this s a unique configuration where the UG IMC extended all the way up to an elevation near the bottom of the face panels at a point where older OH service had originally entered and whose service conductors connected through the weatherhead attached at the top of the ¾” EMT service riser]. 2. In Existing Electrical Riser Diagram, for clarity please add two short conduit runs between the meter socket box and 122 panel and between the two ballasts 3. In New Electrical Riser Diagram, remove two orphan parallel vertical running out of top of 122 panel that appear to represent existing ¾” service EMT to be removed. 4. In New Electrical Riser Diagram, below 122 panel there are five close vertical lines; the two furthest to the right (south) do not appear to represent anything and need to be deleted and the two added lines furthest to the left (north) are now added to depict new 2 ½” IMC conduit and should be solid rather than dotted (the middle line appears to represent the I-beam edge). 5. In Title Block, please indicate Sheet 2 of 2 |
Final Status
| Task End Date | Reviewer's Name | Type of Review | Description |
|---|---|---|---|
| 11/05/2020 | HTHRALL1 | APPROVAL SHELF | Review Comp |
| 11/05/2020 | HTHRALL1 | OUT TO CUSTOMER | Completed |
| 11/05/2020 | HTHRALL1 | REJECT SHELF | Completed |