Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you can not find what you are looking for please submit a records request.
Permit Review Detail
Review Status: Completed
Review Details: RESUBMITTAL - TI ALL
Permit Number - T17CM04472
Review Name: RESUBMITTAL - TI ALL
Review Status: Completed
| Review Date | Reviewer's Name | Type of Review | Description | Status | Comments |
|---|---|---|---|---|---|
| 06/14/2017 | MARTIN BROWN | FIRE | REVIEW | Reqs Change | Unable to locate the response letter. Please see comments from first submittal, address concerns, resubmit plans with a response letter. |
| 06/20/2017 | ERIC NEWCOMB | BUILDING-COMMERCIAL | REVIEW | Reqs Change | 1. Sheet TS1, Title Sheet. References are made to "accessible adjacent space" throughout the page, therefore it is assumed the work area is a portion of a larger tenant space. Please include the total occupant load and a floor plan of the adjacent space which accurately depicts a means of egress plan. 2. Sheet TS1, Title Sheet. Plumbing fixture count for women denotes 1 toilet is required, 1 provided in adjacent space. Include a floor plan of the adjacent space which accurately depicts the location and access of the required women's toilet. 3. Sheet TS1, Title Sheet. Please include in the plumbing fixture count the number and location of required lavatories for women. 4. Sheet TS1, Title Sheet. Plumbing fixture count denotes the required lavatory for men is in an adjacent space. Is Restroom 2 identified in Keynote 1 on sheet A1.0 the men's restroom? Please clarify and revise as necessary. 5. Sheet A1.0, Floor Plan. Wall Type Schedule, Wall B references detail 1/A1.0. Should this be 2/A2.0? Clarify and revise as necessary. 6. Sheet A1.0, Floor Plan. Keynote 9, existing partition to be removed is denoted in Radiology Room 125. This wall is also identified by Wall Type B, New 1 hour fire rated wall. Please clarify. 7. Sheet A1.0, Floor Plan. Keynote 10, existing mop sink to be removed could not be located on the plan. Please identify. Also, please identify the location of available mop sink required by IBC Table 2902.1. If located in adjacent space, refer to floor plan notes in comment 1. 8. Sheet A1.0, Floor Plan. Keynote 16 indicates partial removal of the exterior wall. Please denote the size of the existing opening and size of the proposed opening. Please include header information as applicable to any change in opening size. 9. Sheet A1.0, Floor Plan. Hall 101 and 110 is considered an exit corridor and thus requires a 1 hour fire resistance rating in accordance with IBC Table 1018.1 and constructed in accordance with IBC 708. Portions of the corridor (near 100, 102, 103, 104, 115, restroom 2, and ultrasound) does not appear to be 1 hour rated. 10. Sheet A1.0, Floor Plan. Openings shall comply with IBC Section 716. Doors 115A and 116A are not rated. 11. Sheet A1.0, Floor Plan. Penetrations in fire rated walls shall comply with IBC Section 714. Please include reference to fire stop system to be used for penetrations. 12. Sheet A2.0, Reflected Ceiling Plan. Please include location of emergency lights. 13. Sheet A2.0 Reflected Ceiling Plan. While reviewing the location of exit signs and emergency lights it was noticed that the floor plan used on Sheet E2.0, Lighting Plan, is not consistent with architectural floor plan. Please coordinate with other designers to provide consistency with all plan sheets. 14. General: Provide written responses to all comments. |
| 06/22/2017 | BETH GRANT | COMMERCIAL IMPACT FEE | COMMERCIAL IMPACT FEE PROCESSING | Passed | |
| 06/27/2017 | ROBERT SHERRY | PLUMBING-COMMERCIAL | REVIEW | Reqs Change | 1. Provide structural calculations and details for supporting the relocated 50-gallon water heater above the ceiling. Reference: Section 301.2, IPC 2012. 2. Verify the total quantity of oxidizing compressed gas stored in room 116; detail 2/P1.1 appears to show quantities of compressed oxidizing gases in excess of those allowed in an interior location without the special construction required by Section 502.9.1, IMC 2012. |
| 07/11/2017 | DAN SANTA CRUZ | ELECTRICAL-COMMERCIAL | REVIEW | Approved |