Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you can not find what you are looking for please submit a records request.
Permit Review Detail
Review Status: Completed
Review Details: COMMERCIAL - TI
Permit Number - T11CM03395
Review Name: COMMERCIAL - TI
Review Status: Completed
Review Date | Reviewer's Name | Type of Review | Description | Status | Comments |
---|---|---|---|---|---|
11/15/2011 | ERIC NEWCOMB | BUILDING-COMMERCIAL | REVIEW | Approved | |
11/15/2011 | GERRY KOZIOL | WWM | REVIEW | Approved | |
11/15/2011 | RAY MAJUTA | ELECTRICAL-COMMERCIAL | REVIEW | Approved | |
11/15/2011 | LOREN MAKUS | ENGINEERING | REVIEW | Approved | |
11/18/2011 | ROBERT SHERRY | MECHANICAL-COMMERCIAL | REVIEW | Approved | |
11/18/2011 | ROBERT SHERRY | WATER | REVIEW | Approved | |
11/21/2011 | ROBERT SHERRY | PLUMBING-COMMERCIAL | REVIEW | Denied | 1. Comment not resolved. Detail 2/M1.0 calls for the contractor to evaluate the existing gas piping system and modify it to accommodate the new gas load; this constitutes the practice of engineering. Provide complete plans of the proposed revisions to the gas distribution system. The plans shall include showing how the existing gas piping system will be modified and provide sufficient information to determine if the design meets the requirements of the plumbing code. Reference Arizona Revised Statutes 32-125, Board of Technical Registration Rules R4-30-304. [Original comment: Provide a natural gas piping design, including the piping layout on a floor plan and a natural gas schematic showing the sizes, loads and developed lengths of the piping. Reference: Sections 103.2.3 and 1217.0, UPC 2006.] 2. Revise the water heater detail to show the vacuum relief valve installed per the manufacturer's listing information (i.e. on the cold water inlet and with no valves located between the vacuum relief and the storage tank). [Original comment: Provide a vacuum relief for storage-type water heaters located above any fixture outlets. Install the vacuum relief per the manufacturer's listing information (i.e. on the cold water inlet and with no valves located between the vacuum relief and the storage tank). Reference: Sections 304.0 and 608.7, UPC 2006.] 3. Show the installation of a cleanout for the mop sink. [Original comment: Provide upper terminal cleanouts on horizontal drainage pipes exceeding 5 feet in length (horizontal drain lines serving sinks require cleanouts regardless of length). Reference: Section 707.4, UPC 2006.] |
Final Status
Task End Date | Reviewer's Name | Type of Review | Description |
---|---|---|---|
01/31/2012 | CINDY AGUILAR | OUT TO CUSTOMER | Completed |
01/31/2012 | SUE REEVES | REJECT SHELF | Completed |