Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you cannot find what you are looking for please submit a records request.

PRO is currently experiencing an outage. Some documents and records may not be available on PRO momentarily. We apologize for the inconvenience and are working to restore full access.

Permit Review Detail

Permit Number: T10EL01261
Parcel: 12407176B

Review Status: Completed

Review Details: BILLBOARD-BLDG/ELEC30days

Permit Number - T10EL01261
Review Name: BILLBOARD-BLDG/ELEC30days
Review Status: Completed
Review Date Reviewer's Name Type of Review Description Status Comments
09/07/2010 LEERAY HANLY BUILDING-COMMERCIAL REVIEW Approved
09/07/2010 LEERAY HANLY ELECTRICAL-COMMERCIAL REVIEW Approved
09/20/2010 GLENN MOYER ADMINISTRATIVE ADMIN REVIEW Denied BRC Comments

Comments below are for the lighting modification & electrical repair
resubmittal for COT ID# 334 at 730 East Broadway Boulevard (T10EL01261 [not
T10EL01287]).

Sheet 2 of 3

1. Panel Schedule: correct the volt-amp entries for Circuits #1 and #3 and
associated sums; based on input watts specified by the manufacturer (467
watts per two lamp fixture (F96T12VHO)) and the 125% continuous load factor
that the EOR has been including in the panel schedule, this figure should be
1167.5 v-a for each circuit (or appropriately rounded up); if otherwise,
provide the calculations as to how the v-a entry was arrived at; these
entries need to be standardized for all pending and future panel schedules.

2. Elevation: the addition of the One-Line Diagram & the changes to the
Partial Plan View do not fully clarify the wiring/conduit configuration; to
address this: designate the apparent tee to the right of the double gang
junction boxes as a tee (or otherwise); add the number of conductors and
conduit type/size for the run of conduit between the two junction boxes
(delete the existing designation of (6) #18 on this run, which appears to be
intended for the vertical liquid tite/EMT runs to the left support arms;
based on the design, it would appear that there would be either zero or (12)
#18 conductors in this run); add the number of conductors and conduit
type/size between the right junction box and tee; add the number of #12
conductors in the ¾" EMT runs between the ballasts and the junction boxes;
and, if possible, add the detail on the ballast area that was provided in
other recent submittals.

3. Title Block: include COT Activity No. (as in all resubmittals).

Final Status

Task End Date Reviewer's Name Type of Review Description
09/22/2010 CINDY AGUILAR OUT TO CUSTOMER Completed
09/22/2010 SUE REEVES REJECT SHELF Completed