Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you cannot find what you are looking for please submit a records request.

Permit Review Detail

Permit Number: T06EL00539
Parcel: 126020190

Address:
4657 E 1ST ST

Review Status: Completed

Review Details: ELECTRICAL

Permit Number - T06EL00539
Review Name: ELECTRICAL
Review Status: Completed
Review Date Reviewer's Name Type of Review Description Status Comments
04/03/2006 LINDA BUCZYNSKI ELECTRICAL-COMMERCIAL REVIEW Denied TRANSMIT ORIGINAL DRAWINGS WITH NEXT SUBMITTAL.

PLEASE CALL AT 791-5550 X1106 OR EMAIL AT Linda.Buczynski@tucsonaz.gov
IF YOU CARE TO DISCUSS.

1. Air compressor is on Ckt B-22,24 on Floor Plan, but on Ckt B-10,12 on the panel schedule. Please clarify.
2. B-9,11 and B-13,15 powering Lifts, appear to draw 16A, but are on 15A circuits. Please clarify.
3. Change the #3 to 1/0 bond for Grounding Electrode Conductor at the service and for Main Bonding Jumper. Reference NEC Table 250.66.
4. Put the following note on the plans: "Contractor shall provide Available Fault Current at service. Fault current rating of all equipment shall be equal to or greater than the available fault current at its point of installation."
5. Article 513 has been cited in the Class I Division 2 notes. This Article pertains to Aircraft Hangers. It appears the intent is to cite Article 511.
6. Specify the horizontal component of the under-floor conduit. If rigid non-metallic conduit is specified, please change 12" in Note 1 to read 24". Reference NEC 511.4 (A) (1) Exception and Handbook commentary p. 691.
7. Provide a cut sheet for the compressor. Electrical Plans Examiner to evaluate compliance with NEC 501.8 (B) and for the height of the installed disconnect switch.
8. Specify a mounting height for the Lift disconnects, or add them to Note 2.
9. There is not enough information on the plans to determine compliance with NEC 511.7 (B) (1) (b). Please specify mounting height of new luminaries, and submit lighting fixture cut sheets.
10. Specify GFCI protection for receptacles in areas where electrical diagnostic equipment, electrical hand tools, or portable lighting equipment are to be used. Reference NEC 511.12.

Final Status

Task End Date Reviewer's Name Type of Review Description
04/14/2006 AMERY KLAPPERT OUT TO CUSTOMER Completed
04/14/2006 SUE REEVES REJECT SHELF Completed