Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you cannot find what you are looking for please submit a records request.

Permit Review Detail

Permit Number: T02CM02508
Parcel: 123050890

Review Status: Completed

Review Details: RESIDENTIAL BLDG/ZONING/FLOOD/WWM

Permit Number - T02CM02508
Review Name: RESIDENTIAL BLDG/ZONING/FLOOD/WWM
Review Status: Completed
Review Date Reviewer's Name Type of Review Description Status Comments
05/20/2002 PATRICIA GEHLEN ZONING REVIEW Approved
05/20/2002 PATRICIA GEHLEN NPPO REVIEW Passed
05/20/2002 BLANCA ESPINO FLOODPLAIN REVIEW Approved
06/17/2002 DAVE WITT BUILDING-RESIDENTIAL REVIEW Denied PLAN CHECK COMMENTS - PROJECT #T02CM02508

6/17/02 2102 E. HAMPTON ST.

PLAN REVIEW FOR THE ABOVE REFERENCED STRUCTURE HAS BEEN COMPLETED. THIS LETTER REFLECTS COMMENTS TO BE ADDRESSED. IN ORDER TO FACILITATE A SHORTER BACK CHECK TIME, WE REQUEST THAT YOU PLEASE PROVIDE REVISED PLANS AND CALCULATIONS, HIGHLIGHTING ANY CHANGES, ALONG WITH A WRITTEN RESPONSE TO EACH OF THE NOTED ITEMS INDICATING ACTION TAKEN.

SCOPE OF REVIEW:

THE SCOPE OF THIS PLAN REVIEW COVERS ARCHITECTURAL, PLUMBING, MECHANICAL, MODEL ENERGY AND ELECTRICAL CODES. ALL CODE REFERENCES ARE TO THE 2000 IRC AND STATE PLUMBING CODE. ALL FEATURES WERE CHECKED ONLY TO THE EXTENT ALLOWED BY THE SUBMITTALS PROVIDED. ALL PORTIONS OF THIS PROJECT ARE ASSUMED TO MEET OR WILL MEET OTHER DEPARTMENTAL REQUIREMENTS, CONDITIONS AND CONCERNS BEFORE PERMIT APPROVAL.

GENERAL REQUIREMENTS:

1. ALL CORRECTIONS AND REVISIONS SHALL BE MADE ON THE ORIGINAL TRACINGS AND TWO NEW SETS OF PRINTS OR (1) SEPIA & (1) BLUE LINE SHALL BE RETURNED ALONG WITH ALL REDLINE PRINTS.

2. PEN OR PENCIL CORRECTIONS ON FINAL PRINTS WILL NOT BE ACCEPTABLE. TO AVOID DELAYS ENSURE ALL CORRECTIONS HAVE BEEN MADE, ARE COMPLETE AND HAVE BEEN COORDINATED ON ALL APPLICABLE DETAILS AND NOTES.


FOUNDATION PLANS:


1. PROVIDE THE FOOTING WIDTHS FOR DETAIL 7 ON PAGE 4 AND DETAIL 3 ON PAGE 4 IN ACCORDANCE WITH TABLE R404.1.1(4) OF THE I.R.C.


FLOOR PLANS:


1. NOTE THAT BATHTUB AND SHOWER ENCLOSURES SHALL BE FINISHED PER p2710 WITH CERAMIC TILE, OR A
LISTED ENCLOSURE, TO A HEIGHT OF 72" ABOVE THE DRAIN PER R702.4 AND R307.2

2. NOTE AND SPECIFY THAT SHOWER ENCLOSURES SHALL HAVE A MINIMUM FINISHED INTERIOR OF 1,024 SQUARE INCHES AND SHALL BE CAPABLE OF ENCOMPASSING A MINIMUM 30" CIRCLE PER UPC SEC. 410.0. ALL GLASS ENCLOSURES SHALL BE TEMPERED.

3. SHOW THAT EACH WATER CLOSET IS LOCATED IN A CLEAR SPACE NOT LESS THAN 30" WIDE AND HAS A
CLEAR SPACE IN FRONT OF NOT LESS THAN 24" PER R307.2 (FIGURE).

4. THE 8" RISER SPECIFIED ON PAGE 2 EXCEEDS THE MAXIMUM RISER HEIGHT IS 7 ¾" PER R314.


STRUCTURAL PLANS:

1. WHICH SERIES TJI WILL BE USED FOR RAFTERS.

2. WHAT RECEIVES THE POINT OF THE LAG BOLTS SECURING THE GUARD RAILS.

3. PROVIDE MANUFACTURER'S DATA FOR PRE-FAB TRUSSES. TRUSS
CALCULATIONS MUST BE SIGNED, DATED AND WET-SEALED BY AN ENGINEER WHO IS REGISTERED IN
ARIZONA.

4. SUPPORT THE ROOF DECK BENEATH THE MANSARD FRAMING.

6. SPECIFY THE HANGER IN DETAIL 6 ON PAGE 6.



16. PRE-FABRICATED METAL STAIR SHALL HAVE MANUFACTURER`S SPECIFICATIONS ATTACHED TO THE PLANS.


ELEVATIONS:

1. INDICATE THE ROOFING MATERIAL USED ON THE MANSARD AND THE HIP ROOFS.



9. FOR VENEER, SPECIFY THE SPACING FOR THE VENEER TIES. SPECIFY THE WEEP HOLES IF THE VOID ISN`T GROUTED SOLID (R703.7.6). SPECIFY THE FLASHING (703.8).



SECTIONS - DETAILS - MISC. NOTES:

1. ARE THE SECTIONS SHOWN ON THE ROOF FRAMING PLAN SHOWN ON PAGE 3?

PLUMBING PLANS:

1. COMPLETE THE SIZING OF THE WATER DISTRIBUTION ISOMETRIC.


MECHANICAL PLANS:

1. SIZE THE COMBUSTION AND RELIEF AIR GRILLS IN THE DOOR TO THE FURNACE/WATER HEATER ROOM. NOTE ON PLANS: MECHANICAL SHALL COMPLY WITH CHAPTERS 12 - 24 2000 IRC.

ELECTRICAL PLANS:


1. ARE THE LIGHTS ABOVE THE TUB SUITABLE FOR WET LOCATIONS?

2. WHERE CEILING FANS ARE SHOWN ON THE PLANS, PROVIDE A NOTE INDICATING ONLY APPROVED
OUTLET BOXES SHALL BE USED, PER E4001.6.

3. NOTE THAT LIGHT FIXTURES IN CLOTHES CLOSETS SHALL BE INSTALLED IN ACCORDANCE WITH E3903.11.

4. SHOW LOCATIONS OF SMOKE DETECTORS PER R317. NOTE THAT ALL SMOKE DETECTORS MUST BE
INTERCONNECTED WITH A POWER SOURCE FROM THE BUILDING WIRING, AND SHALL BE EQUIPPED WITH
BATTERY BACKUP.


IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT YOUR ASSIGNED PLANS EXAMINER:
DAVE WITT @ 791-5550 EXT. 110
06/19/2002 GERRY KOZIOL WWM REVIEW Denied

Final Status

Task End Date Reviewer's Name Type of Review Description
06/19/2002 MONICA VALDEZ OUT TO CUSTOMER Completed