Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you cannot find what you are looking for please submit a records request.

Permit Number: TC-RES-1224-07133
Parcel: 126062750

Address:
612 N TEXAS CI

Review Status: Requires Resubmit

Review Details: RESIDENTIAL NEW DWELLING v.1

Permit Number - TC-RES-1224-07133
Review Name: RESIDENTIAL NEW DWELLING v.1
Review Status: Requires Resubmit
Review Date Reviewer's Name Type of Review Description Status Comments
12/24/2024 Residential Building APPROVED
01/09/2025 Site Engineering NOT REQUIRED
12/19/2024 Site Landscape NOT REQUIRED
01/10/2025 Bldg Permits - Post Review Express PENDING ASSIGNMENT
01/10/2025 Site Zoning REQUIRES RESUBMIT PDSD TRANSMITTAL

FROM: Ramiro Olivarez
Zoning Review Section

PROJECT: TC-RES-1224-07133
612 N TEXAS CI TUCSON, AZ 85711 – R-1 Zoning
Laundry, Arizona Room, Master Bedroom Extension (1st Review)

TRANSMITTAL DATE: 01/10/2025

This site is located in the R-1 zone (UDC 4.7.8). A single-family residence is permitted use in this zone (Table 4.8-2) subject to Use Specific Standards 4.9.7.B.5 - .9

COMMENTS: Please resubmit revised drawings and a detailed response letter, which states how all Zoning Review Section comments were addressed.


1. Comment: Ensure Lot Coverage Calculations are correct.

Lot coverage calculations include a dimensioned vehicular use area, as noted in the sample plot plan requirements. The sample plot plan can be found here, https://www.tucsonaz.gov/files/sharedassets/public/v/1/pdsd/documents/permits/residential-permits/residential_plot_plan_requirements.pdf

Comparing the lot coverage calculations to the most recent site plan approval (permit # T10CM00513), the calculations are not consistent with the approved site plan (i.e. the workshop square footage is 672 SF not 389 SF). Correct the lot coverage calculations.

See the last approved site plan on permit # T10CM00513 as a reference. ( File name 001_T1.0.TIF | https://pro.tucsonaz.gov/permitdetails/T10CM00513/ )


2. Comment: On the Rear and Side elevations draw, label, and dimension the height of the wall measured from design grade (the ground, where the dirt meets the bottom of the wall) to the highest point of the wall. This is to ensure that setbacks are met/complaint.
3. Comment: Additional comments may be forthcoming on the next review based on the proposed use for the addition and applicable use specific standards.

RESUBMITTAL OF THE FOLLOWING IS REQUIRED: Provide corrected site plan information in the next submittal.

If you have any questions about this transmittal, please contact Ramiro Olivarez Ramiro.Olivarez@tucsonaz.gov
12/10/2024 PDSD Application Completeness Express REVIEW COMPLETED