Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you can not find what you are looking for please submit a records request.
Permit Review Detail
Review Status: In Review
Review Details: RESIDENTIAL FENCE/WALL v.2
Permit Number - TC-RES-0724-03981
Review Name: RESIDENTIAL FENCE/WALL v.2
Review Status: In Review
| Review Date | Reviewer's Name | Type of Review | Description | Status | Comments |
|---|---|---|---|---|---|
| N/A | Bldg Permits - Post Review | PENDING ASSIGNMENT | |||
| N/A | Residential Building | PENDING ASSIGNMENT | |||
| 12/31/2024 | Site Engineering | REQUIRES RESUBMIT | 1. Please address the previous zoning comments regarding the wall in excess of 6ft in height. 2. The wall details shows specs for the footing that do not meet the requirements of PAG109 for screen walls. Walls up to 6ft high require a 20in wide footing with 3 #4 (No. 13) horizontal bars. Walls up to 6ft 8in high require a 22 inch footing with 3 #4 (No. 13) horizontal bars. Please apply for a TSMR if these requirements will not be met. Mike Ortiz michael.ortiz@tucsonaz.gov |
||
| 01/02/2025 | Site Zoning | REQUIRES RESUBMIT | PDSD TRANSMITTAL FROM: Bobby Parsons Zoning Section Review PROJECT: TC-RES-0724-03981 2340 E 8th Street Tucson, AZ 85719 Sam Hughes Villas Lot 4 Wall(2nd Review) TRANSMITTAL DATE: 1/2/2025 This site is located in the R-1 zone (UDC 4.7.8). A single-family residence is a permitted use in this zone (Table 4.8-2) subject to Use Specific Standards 4.9.7.B.5 - .9. Comments: Please resubmit revised drawings along with a detailed response letter which states how all Zoning Review Section comments were addressed. 1. Comment: Previous comment 1 not addressed. Per UDC Article 6.6.2.I, “the maximum height of a wall or fence within a perimeter yard shall be 6’, but no higher than 10’, if: (See figure 6.6.1-A, Height of Wall or Fence within a side or rear perimeter yard.) a. At least 75% of the area above 6’ in height is left unobstructed and open through the use of architectural elements, such as arches, columns, or wrought iron; b. Part of, or located on top of, a retaining wall no higher than ten feet measured from design grade and no higher than six feet measured from the top of the retaining portion of the wall; c. A greater height is required through the rezoning process or the special exception land use process; d. A greater height is required by a specific UDC standard. It does not appear that the proposed 6’-6” high wall called out under keynote 2 meets any of the 4 exceptions mentioned above. Either the wall needs to be lowered to 6’-0” or a Design Development Option (DDO) for wall height will need to be submitted and approved prior to approval of this plan. Here is a link to the DDO application: https://www.tucsonaz.gov/files/sharedassets/public/v/1/pdsd/documents/planning-amp-zoning/ddo_for_setback_and_height_udc.pdf . If you have questions about the DDO application process, please contact Georgia Pennington at Georgia.Pennington@tucsonaz.gov or Mark Castro at Mark.Castro@tucsonaz.gov If you have any questions about this transmittal, please contact Bobby Parsons at Robert.Parsons@tucsonaz.gov. |
||
| 12/14/2024 | PDSD Application Completeness | REVIEW COMPLETED |