Permit Review Detail
Review Status: Requires Resubmit
Review Details: RESIDENTIAL NEW DWELLING v.1
Permit Number - TC-RES-0224-01207
Review Name: RESIDENTIAL NEW DWELLING v.1
Review Status: Requires Resubmit
| Review Date | Reviewer's Name | Type of Review | Description | Status | Comments |
|---|---|---|---|---|---|
| 03/01/2024 | Fire New Construction | NOT REQUIRED | |||
| 03/18/2024 | Site Engineering | NOT REQUIRED | |||
| 04/02/2024 | Bldg Permits - Post Review Express | PENDING ASSIGNMENT | |||
| 03/11/2024 | Residential Building | REQUIRES RESUBMIT | Provide a complete construction plan set showing 2018 IRC compliance after DDO approval. | ||
| 04/02/2024 | Site Zoning | REQUIRES RESUBMIT | FROM: PDSD Zoning Review Section PROJECT: TC-RES-0224-01207 2723 E DRACHMAN ST. - R-1 Detached Shop (4th Review) TRANSMITTAL DATE: April 2, 2024 Provided a detailed comment response letter with your submittal that clearly shows how you have addressed all comments with your next submittal. This site is located in the R-1 zone (UDC 4.7.8). A single-family residence is a permitted use in this zone (Table 4.8-2) subject to Use Specific Standards 4.9.7.B.5 – 9. The following comments are based on sheet 5, Existing Site Plan: 1. Provide a residential plot plan that meets the requirements found at: https://www.tucsonaz.gov/Departments/Planning-Development-Services/Building-Safety/Plan-Examples/Plot-Plan-Example, to include but not limited to: a. Provide a lot coverage calculation that meets the requirements of Unified Development Code (UDC) Article 6.4.3 and the example shown on the Residential Plot Plan Requirements. b. Indicated the zoning of this parcel and all adjacent parcels. c. Provide the property dimensions on the plot plan. 2. UDC Per Article 6.6.3.D accessory structures, except for accessory dwelling units, shall not exceed 12 feet in height, unless attached to a principal structure. If attached to the principal structure, maximum height permitted shall be the same as for the principal structure. Per UDC Article 6.4.4.A measurement of Building Height, building height is the vertical distance measured from the design grade elevation to the highest point of a flat roof; (See Figure 6.4.4-A, Measurement of Building Height.) Provide a building height dimension on the elevations or sections from design grade to the highest point of the proposed flat roof. If this dimension exceeds 12’-0” a Board of Adjustment for Variance will be required. 3. UDC Per Article 6.6.3.E the total gross floor area (gfa) of all accessory structures shall not exceed 50% of the gfa of the principal structure. Accessory structures less than 200 square feet gfa and accessory dwelling units are exempt from this requirement. Gross floor area is defined as The sum of the horizontal areas of all floors of all buildings , including accessory buildings on a lot , measured from the exterior faces of the exterior walls or from the centerline of walls separating two buildings and includes elevator shafts and the stairwells at each story. Gross floor area includes floor space with structural headroom of six feet and six inches or more used for mechanical equipment; penthouses; attic space; interior balconies; mezzanines; and service bays but does not include any interior space used for parking, loading, or loading space that is incidental to the principal use. Provide the gross floor area for the existing residence and a calculation that demonstrates what percentage of the residence gfa the proposed shop is. If the shop exceeds 50% a Board of Adjustment for Variance will be required. 4. Perimeter yard setbacks are based on a wall height measurement from design grade to the highest point of the exterior wall UDC Article 6.4.5.B & Figure 6.4.5-A. As wall heights from design grade were not provided Zoning as added 6” to the 14’-8” height provided on the East-West Section, sheet 7 to determine perimeter yard setback requirements. Per UDC Table 6.3-2.A the required perimeter yard setback from the proposed shop to the north and west property line is 6’-0” or 2/3 (H), (H) = Height of the proposed exterior building wall, great of the two dimensions apply. Based on a wall height of 15’-2” the required perimeter yard setback form the proposed shop to the north and west property line is 10’-2”, proposed setbacks to the north and west property line are 5’-0”. The reduced setbacks can be dealt with in one of 3 ways. 1) Provide a neighbors setback waiver, see requirements below. 2) Submit a Design Development Option (DDO), see requirements below. 3) If you end up applying for the Board of Adjustment the reduces setbacks and be included in the process. Board of Adjustment application/requirements can be found at: https://www.tucsonaz.gov/Departments/Planning-Development-Services/Planning-Zoning-Applications/Zoning-Administration. Contact for the Board of Adjustment is Mark Castro at Mark.Castro@tucsonaz.gov. DDO application and requirements can be found at: https://www.tucsonaz.gov/Departments/Planning-Development-Services/Planning-Zoning-Applications/Zoning-Administration. If you have questions about the DDO application or process please contact Wyatt Berger at Wyatt.Berger@tucsonaz.gov or Georgia Pennington at Georgia.Pennington@tucsonaz.gov. To secure this neighbor setback waiver the following statement must be provided on the plot plan and be signed and dated by the adjacent property owner(s): My Name is____________________ and I am the owner of the property located at_______________________. I have reviewed the site plan and I have no objection to structure being located or constructed________ feet from the property line as depicted on the site plan. Signature: _____________________________ Date: _________________________________ The Unified Development Code (UDC) can be found at: https://www.tucsonaz.gov/Departments/Planning-Development-Services/Codes/Zoning-Code#section-1. If you have any questions about this transmittal, please contact Zone1.desk@tucsonaz.gov. |
||
| 02/29/2024 | PDSD Application Completeness Express | REVIEW COMPLETED | |||
| 03/18/2024 | Site Landscape | REVIEW COMPLETED |