Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you can not find what you are looking for please submit a records request.
Permit Review Detail
Review Status: Requires Resubmit
Review Details: RESIDENTIAL NEW DWELLING v.5
Permit Number - TC-RES-0123-02041
Review Name: RESIDENTIAL NEW DWELLING v.5
Review Status: Requires Resubmit
| Review Date | Reviewer's Name | Type of Review | Description | Status | Comments |
|---|---|---|---|---|---|
| 08/19/2024 | Bldg Permits - Post Review | PENDING ASSIGNMENT | |||
| 08/19/2024 | Site Zoning | REQUIRES RESUBMIT | ZONING REVIEW TRANSMITTAL FROM: PDSD Zoning Review PROJECT: TC-RES-0123-02041 - CE-VIO0723-04363 738 S CAMINO SECO - R-1 Site Wall (2nd Review) TRANSMITTAL: August 19, 2024 Provided a detailed comment response letter with your submittal that clearly shows how you have addressed all comments with your next submittal. This site is located in the R-1 zone (UDC 4.7.8). A single-family residence is a permitted use in this zone (Table 4.8-2) subject to Use Specific Standards 4.9.7.B.5 – 9. 1. As the proposed site wall does not meet any of the 4 following requirements a Design Development Option (DDO) for wall height shall be submitted and approved. For any section of the wall over 6’-0” high. Zoning acknowledges that a partial DDO application was submitted but until the DDO is approved Zoning cannot approve this plan. The proposed 7’-0” & 6’-2” wall exceeds the allowed height of a all within the perimeter yard, see UDC Article 6.6.2.I. Per UDC Article 6.6.2.I The maximum height of a wall or fence within a perimeter yard shall be six feet; however, the wall or fence may be higher than six feet, but no higher than ten feet, if: (See Figure 6.6.1-A, Height of Wall or Fence within a Side or Rear Perimeter Yard.) 1. At least 75% of the area above six feet in height is left unobstructed and open through the use of architectural elements, such as arches, columns, or wrought iron; 2. Part of, or located on top of, a retaining wall no higher than ten feet measured from design grade and no higher than six feet measured from the top of the retaining portion of the wall; 3. A greater height is required through the rezoning process or the special exception land use process; or, 4. A greater height is required by a specific UDC standard. Either demonstrate that one of the four exceptions above are met or a Design Development Option for wall height will need to be summited and approved prior to approval of this plan. The Unified Development Code (UDC) can be found at: https://www.tucsonaz.gov/Departments/Planning-Development-Services/Codes/Zoning-Code. If you have any questions about this transmittal, please contact Zone1.desk@tucsonaz.gov naz.gov |
||
| 08/06/2024 | PDSD Application Completeness | REVIEW COMPLETED |