Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you cannot find what you are looking for please submit a records request.

Inspection History Details

Permit: T08CM02756

Parcel: 125111880


Addresses:

770 N DODGE BL

Inspection Status: Approved

Inspection History: ELECTRIC - INTERMEDIATE

Date Description Inspector Results Comments
05/06/2009 ELECTRIC - INTERMEDIATE Approved IVRS - Inspection :*
05/04/2009 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
04/27/2009 ELECTRIC - INTERMEDIATE Not ready for Inspection IVRS - Inspection :*
04/01/2009 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
03/31/2009 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
1. GROUND METAL BOXES USING APPROVED METHODS
2. BOX OVERFILLED #32
3. AT PANELS GROUND BARS - CLEAN SURFACE AND NO SHEETMETAL THREAD SCREWS
4. SMOKE DETECTOR SHOULD NOT BE IN KITCHEN
5. SUPPORT NM CABLE 12" OF CANS
03/27/2009 ELECTRIC - INTERMEDIATE Not ready for Inspection IVRS - Inspection :*
CANCELED
03/12/2009 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
03/11/2009 ELECTRIC - INTERMEDIATE Not ready for Inspection IVRS - Inspection :*
03/03/2009 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
02/19/2009 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
12/19/2008 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
OK 1-8 AFTER CORRECTIONS 12-14
1. PROTECT CABLE AT STUDS
2. MISSING "P" RINGS
10/29/2008 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
OK ROUGH ELECTRIC 2ND FLOOR
EXCEPT AT AIR HANDLERS & FINISH #31 & #32
10/28/2008 ELECTRIC - INTERMEDIATE Not ready for Inspection IVRS - Inspection :*
10/09/2008 ELECTRIC - INTERMEDIATE Partial Approval IVRS - Inspection :*
1) CONDUCTOR TO BE 6" PAST EDGE OF BOX
2) FILL UNUSED OPENINGS AND SECURE NM TO BOX
3) FINISH RECESSED CANS
4) FINISH #5, 12 & 13 PREVIOUS INSPECTION
09/19/2008 ELECTRIC - INTERMEDIATE Not ready for Inspection IVRS - Inspection :*
1. PROTECT VDV CABLING
2. EXTENSION BOXES TO BE CONNECT
3. MAKE UP BOXES
4. SCREWS NOT ALLOWED INSIDE OF BOXES
5. GROUND METAL BOXES
6. SUPPORT ALL NM CABLES WITHIN 12" OF BOXES & CANS
7. PLEASE OPEN CEILING TO INSPECT
8. SECURE NM CABLE TO BOXES
9. USE APPROVED SPLICE CONNECTORS
10. PROTECT NM CABLES AT STUDS
11. CONNECTORS NEEDED EXHAUST FAN & VERIFY WIRE FILL
12. EXPOSED CONDUCTORS
13. PLEASE DETERMINE IF THESE UNITS ARE A GROUNDED SYSTEM