Microfiche records prior to 2006 have not been completely digitized and may not be available yet on PRO. If you cannot find what you are looking for please submit a records request.

Inspection History Details

Permit: T04CM03839

Parcel: 106063930


Addresses:

1132 W KNOX PL

Inspection Status: Approved

Inspection History: BUILDING - FINAL

Date Description Inspector Results Comments
11/21/2005 BUILDING - FINAL Approved IVRS - Inspection :*
1) ITEM 03090 NOT APPLICABLE PER PAPERWORK TURNED IN BY INSPECTOR R. O'HAVER
06/14/2005 BUILDING - FINAL Denied IVRS - Inspection :
See detailed listing on site.| 999*
03/23/2005 BUILDING - FINAL Not ready for Inspection IVRS - Inspection :*
1) FRAME 01035 PARTIAL-NEED 16" HEARTH EXTENSION FIRPLACE (WILL CHECK AT FINAL)
02/02/2005 BUILDING - FINAL Denied IVRS - Inspection :
See detailed listing on site.| 999*
1) PLAN CALLS FOR STUDS 16" SPACING
2) INSTALL SWITCHES, LIGHTS AND OUTLETS PER PLAN
3) INSTALL H2.5'S STUDS TOP AND BOTTOM TO PLATES (SEE PLAN)
4) PUT ELECTRIC ROMEX INTO WALL
5) INSTALL 1/2" ANCHOR BOLTS BOTTOM PLATE INTO CONCRETE 32" SPACING
6) DIG DOWN VERTICALLY TO VERIFY DEPTH OF FOOTING
7) PLAN SHOWS 200 AMP BREAKER PANEL. HAVE PLAN APPROVED SHOWING EXISTING AMP PANEL
8) CONNECT GROUND WIRE TO SWITCH
9) ELECTRICAL SPLICES TO BE IN JUNCTION BOXES (ACCESSIBLE)
10) INSTALL H2.5'S EACH END ALL RAFTERS AT BEARING
11) PLAN CALLS FOR 4 X 8 BEAM HEADER OVER WINDOW AND DBL 2 X 8 OVER SLIDING DOOR
12) INSTALL APPROVED CEILING FAN ELECTRIC BOX
10/28/2004 BUILDING - FINAL Denied IVRS - Inspection :
See detailed listing on site.| 999*/ 1) REMOVE ALL SHEETROCK ON ALL WALLS AND CEILING PER PREVIOUS PAPERWORK
09/23/2004 BUILDING - FINAL Cancelled PER ANGELA
09/23/2004 BUILDING - FINAL Not ready for Inspection IVRS - Inspection :*/ 1) CANCELLED
09/22/2004 BUILDING - FINAL Cancelled PER ANGELA 293-5312
09/22/2004 BUILDING - FINAL Not ready for Inspection IVRS - Inspection :*/ 1) CANCELLED PER PAPERWORK TURNED IN BY R. OHAVER
08/26/2004 BUILDING - FINAL Denied IVRS - Inspection :
See detailed listing on site.| 999*/ 1) ON EXTERIOR DIG DOWN VERTICALLY TO EXPOSE FOOTINGS 2) REMOVE SHEET ROCK ON WALLS AND CEILINGS TO INSPECT FRAMING, ELECTRICAL, MECHANICAL AND GAS 3) EXPOSE ALL GAS LINES AND PRESSURE TEST TO MINIMUM 10 POUND 4) EXISTING PANEL IS NOT A 200 AMP BREAKERED PANEL AS PLAN SHOWS (HAVE PLAN CHANGED TO EXISTING AMPACITY) 5) ALL WORK COMPLETED WITHOUT INSPECTION APPROVAL
08/25/2004 BUILDING - FINAL Not ready for Inspection IVRS - Inspection :*/ 1) NO ANSWER AT DOOR, NO ACCESS-RECALL